To remove the microSD Card from the port, push the card slightly in using the same thin object you did before. There is only one correct direction to insert the microSD Card.ĭo not force the microSD Card into the port doing so may cause damage to both the scope and the card itself. Return the cover to its original position.Use a thin object (small coin, paper clip) to lock the microSD card in place after inserting it into the slot.Always format a new microSD card before using.Make sure that the device is turned off before inserting the formatted micorSD Card into its assigned port. To open the rubber port cover, gently lift the rubber cover and move it out of the way.
You can find them under the rubber caps on the right side of the device (we marked the caps with appropriate icons). The device is equipped with a microSD Card and USB (type C) ports. Battery run time is 16 hours on a single charge.Battery charging time (from 0 to 100%) is 6 hours with 2 A USB charger.Note using a wall charger with lower amperage will take longer to charge your scope. Plug the cable into a USB wall charger that has an output of 2 amps (Wall Charger not included).Ĭharge your scope for 6 hrs using a 2A USB wall charger. We have included a USB (type C) charging cable with your scope. You will find it under the rubber cap on the right side of the device (caps are marked with appropriate icon). The device is equipped with a USB (type C) port. If any accessories are missing or broken contact ATN’s Customer Service at 1.800.910.2862. Ensure that all optical surfaces are clean and ready for use.Inspect the device for damage to optical surfaces, body, eyecups, operation buttons, etc.Open packaging box, remove ThOR 4 and check the contents.The following steps must be performed before using the device:
0 kommentar(er)
